fuel pressure gauge, fuel line to gauge???
02-03-2007, 07:36 PM
#1
Guest
Posts: n/a
fuel pressure gauge, fuel line to gauge???
re-doing dash with all new gauges. reinforced rubber fuel lines going into the back of the old gauges now 
doesnt seam safe to me. carb non-blower motors with mechanical fuel pumps. do i really need the gauges? if so, how can i use an electrical gauge instead? the electrical gauges are 0-100 psi. gauge needle wont move much anyway.
what do you guys recommend?
doesnt seam safe to me. carb non-blower motors with mechanical fuel pumps. do i really need the gauges? if so, how can i use an electrical gauge instead? the electrical gauges are 0-100 psi. gauge needle wont move much anyway.
what do you guys recommend?
02-03-2007, 07:41 PM
#2
Registered
Re: fuel pressure gauge, fuel line to gauge???
Livorsi make an electrical 0-30 PSI fuel gauge.All you need to do is install an inline fitting by the carb that will allow an 1/8 pipe fitting for the electrical sender to be screwed in.Then just connect the wires and you are done.Get rid of that fuel line up under the dash,like you said,not very safe at all.
Nordic95
Nordic95
02-03-2007, 11:37 PM
#4
Registered
Re: fuel pressure gauge, fuel line to gauge???
Steve - my old Cig has the same mech fuel gauges, BUT the new Livorsi electric 0-15 psi just came in Friday with all the others. 
BTW - where are you keeping your Bullet now why you're doing all the upgrages?
BTW - where are you keeping your Bullet now why you're doing all the upgrages?
02-03-2007, 11:58 PM
#5
Guest
Posts: n/a
Re: fuel pressure gauge, fuel line to gauge???
mine is at the upholstery shop for the time being. going to the painter next weekend
