Ignition systems
#11
Registered
Join Date: May 2006
Location: Scottsdale AZ
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Re: Ignition systems
I have Wallys old boat now and I am still runing the same MSD boxes with the adjustable rev limiter that he put on it I think. I am keeping thoughs boxes on there with the new 502 MPIs
#12
Registered
Re: Ignition systems
I'm running the Crane box. I like the built in Rev limiter and choices of curves. The only reason I went with it was that the TB modules didn't have the advance curves I wanted. I'm keeping the stock TB module on the distributor, and wired it so that it only takes one connector change for a backup ignition system.
#13
VIP Member
VIP Member
Re: Ignition systems
I have msd distributors and the Crane HI-6M boxes on my boat. No complaints here..I have had to replace a few msd boxes over the years. The Cranes are pretty cool in that you can adjust them very easily. I'm not sure if it's on every box, but mine seem to kick in about 300rpms early. Not a problem....once I became aware of it!!
__________________
Happily retired and living in Heavens waiting room.
Happily retired and living in Heavens waiting room.
#14
Registered
Re: Ignition systems
I've had enough of bad MSD components. For the past 5 years I'm running plain old Thunderbolt IV with the V-6 modules. Very simple and never let me down.
#15
Were doomed!
Charter Member
Re: Ignition systems
This was durring the rigging....they havent been started yet at this point....this was after the new bilge paint...wiring...the diamond plating on the fire wall and ledge.
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!