TRS vs Bravo 1
#2
Banned
Join Date: Sep 2001
Location: Deland, Florida
Posts: 25,191
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I have a Trs on a 22 Donzi. I can tell you that people in China duck when I motor by.
I have it backed in against my garage wall that I cut out, but I might be able to measure the bottom of the hull up to the outer transom assembly if that will help. Can't help you with the Bravo. My other two performance boats have a surface drive, and an Alpha drive.
![Big Grin](/forums/images/smilies/biggrin.gif)
I have it backed in against my garage wall that I cut out, but I might be able to measure the bottom of the hull up to the outer transom assembly if that will help. Can't help you with the Bravo. My other two performance boats have a surface drive, and an Alpha drive.
#3
Registered
Thread Starter
Join Date: May 2005
Location: Georgian Bay, Ontario, Canada
Posts: 210
Likes: 0
Received 1 Like
on
1 Post
![Default](/forums/images/icons/icon1.gif)
I have all measurements for the Bravo 1 but what I would like to know is bottom of boat to centerline of driveshaft thru the transom assembly on the upper gearcase and where the cavitation plate is relative to the bottom of the boat (distance above or below). I am also guessing yoy "V" bottom is rounded over. Thanks
#4
Banned
Join Date: Sep 2001
Location: Deland, Florida
Posts: 25,191
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
A picture of the bottom. I can measure inside the engine compartment. I'd have to guess where the center of the shaft is, or again, the measurement to the bottom of the inside transom assembly.
Nice looking Hornet by the way.
Nice looking Hornet by the way.
![Smilie](/forums/images/smilies/smile.gif)
#5
Charter Member #232
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
I can tell you that on my formula my drive shaft is 1 foot below the bottom of the boat. My caviation plate is even with the bottom. I am not sure what the centerline to centerline is on them....
Jon
Jon
__________________
Put your best foot forward!
Put your best foot forward!
#7
Registered
![Default](/forums/images/icons/icon1.gif)
Why go from a good drive to a Bravo? If you're going to convert you should consider the Konrad. The TRS to Konrad conersion can be done in HOURS and requires no re-rigging.