How hard is it to replace a gimble ring when the engine is out of the boat?
#1
Registered
Thread Starter
How hard is it to replace a gimble ring when the engine is out of the boat?
Ok you read the title
I was checking the gimble ring before putting the engine back in. It's in bad shape, its even loose on the lower swivel pin I have read previous threads on the topic but can not find a solid answer. The manual makes it sound harder than it looks. Any advise guys
I was checking the gimble ring before putting the engine back in. It's in bad shape, its even loose on the lower swivel pin I have read previous threads on the topic but can not find a solid answer. The manual makes it sound harder than it looks. Any advise guys
#2
Registered
I would go ahead and pull the transom assembly and change it on the bench. It isn't that bad on the bech compared to on the boat. Pulling the upper pin on the boat involves drilling big holes on the sides and plugging them when you're done with the job. While you're there you can also install it with new nuts on the transom assy. Pulling the transom is relatively easy. The "downside" is that you'll get a good look at the condition of the wood in the transom which could lead to a bigger job.
Rene
Rene
#3
Registered
Thread Starter
I would prefer not to drill any holes that is why I am asking how hard it is? It looks as simple as remvoving the steering arm and the six bolts. Hoses, wires, and cables should slide out with housing? What am I missing.
Last edited by 1BIGJIM; 04-09-2007 at 09:02 PM.
#5
Registered
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
Loosen the U-bolt, loosen the nut/bolt on the steering arm, then loosen the top nut from inside the engine bay. Pin should slowly start to drop if you tilt the bell housing out of the way, or take the bell housing off first.
#6
Platinum Member
Platinum Member
Join Date: Nov 2002
Location: LONG ISLAND/LAKE MURRAY
Posts: 2,399
Likes: 0
Received 1 Like
on
1 Post
The only problem you'll have while its still on the transom is loosening the bolt that clamps the the steering lever. That bolt will be next to impossible to torque to the correct spec while on the boat. Your better off removing from the transom. If you need to borrow my Merc manuel let me know.
Also you may want to consider the HP gimbal ring kit.
Also you may want to consider the HP gimbal ring kit.
#7
Registered
Thread Starter
#10
Registered
Don't think this would need to be done with the engine out. Should be able to reach everything from inside the boat, but need some extra hands outside helping.
Loosen the U-bolt, loosen the nut/bolt on the steering arm, then loosen the top nut from inside the engine bay. Pin should slowly start to drop if you tilt the bell housing out of the way, or take the bell housing off first.
Loosen the U-bolt, loosen the nut/bolt on the steering arm, then loosen the top nut from inside the engine bay. Pin should slowly start to drop if you tilt the bell housing out of the way, or take the bell housing off first.
Rene