Injector testing procedutre
06-03-2007, 04:02 PM
#1
Registered
Thread Starter
Injector testing procedutre
What's the best way to test a fuel injector on a Merc. 502 MPI ecm 3? I don't know if the injector itself is bad or if it isn't getting a voltage signal. Can I hook a voltage meter or an LED to the wires of the injector, crank the engine and look for a voltage signal? (There are no error codes.)
06-03-2007, 05:21 PM
#2
Registered
Join Date: Apr 2001
Location: beaumont tx
Posts: 1,703
Likes: 0
Received 0 Likes
on
0 Posts
the injectors should ohm about 10 to 13 ohms, you can use a test light across the injector wires, just dont let it run long like that, look for a good pulse of light from the test light
06-03-2007, 07:32 PM
#3
21 and 42 footers
Platinum Member
Trust me...injectors can destroy a motor. I'm re-building a motor now (with some buddies) that detonated and "came apart" after 2 hours due to bad injectors.
I found out the injectors were my problem by sending them to Marren Fuel Injection (injector.com). He was able to test them and tell me which injectors were the problem.
I found out the injectors were my problem by sending them to Marren Fuel Injection (injector.com). He was able to test them and tell me which injectors were the problem.
