Crane Fireball Ign. help!
06-19-2007, 03:09 PM
#1
Registered
Thread Starter
Join Date: Jul 2005
Location: Fairview, NC
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Crane Fireball Ign. help!
Is anyone using a Crane HI-6M ignition with a magnetic trigger distributor and an Alpha 1 drive? I can't get the ignition cutout on the shift linkage to work. They say this is the first time they have run into this. I cannot imagine that no one else has this combo. I don't expect there are too many running a 400 SBC in a fishin' boat though!
06-19-2007, 06:54 PM
#2
Registered
Join Date: Feb 2005
Location: oceanport nj
Posts: 1,626
Likes: 0
Received 0 Likes
on
0 Posts
The shift interupt is a simple switch. I'd think whatever wire powers the ign module should be wired in line? Crane says to run the green white from the dist to ground?
http://www.cranecams.com/pdf/90006462b.pdf
http://www.cranecams.com/pdf/90006462b.pdf
Thread
Thread Starter
Forum
Replies
Last Post
ratman
General Boating Discussion
0
11-22-2005 06:19 PM
