Dual ram install
06-30-2007, 10:46 AM
#1
Registered
Thread Starter
Dual ram install
The rams extend all the way just before hitting drive extents (it's safe). But, when one ram fully extended the other ram is not fully retracted. It's about 1/8" from being fully retracted. Do they have to bottom/top out together perfectly?
06-30-2007, 10:33 PM
#2
Registered
Join Date: Feb 2005
Location: long island, newyork
Posts: 2,551
Likes: 0
Received 2 Likes
on
2 Posts
essentially yes. it will take a lot of measureing and remeasureing to achieve this. if you truly desire this result, measure with very accurate device's such as large caliper's, or even a tram bar. this is also much easier when the gimbal is off the boat.
good luck.
good luck.
