young performance marine
#12
Registered
Man, I've heard that guy is the SHIZNIT!!!!!
Seriously, thanks everyone for the kind words. I do my best. This isn't really that hard , just do what you say you'll do and don't say you'll do it if you can't. Above all, be upfront and honest.
Kenny, me and you need to have a talk about this yankee stuff.
John, go change your oil!!!!
Seriously, thanks everyone for the kind words. I do my best. This isn't really that hard , just do what you say you'll do and don't say you'll do it if you can't. Above all, be upfront and honest.
Kenny, me and you need to have a talk about this yankee stuff.
John, go change your oil!!!!
#13
Registered
Eddie, I said "SOUNDS" like a yankee. I wasn't implying you were or acted like one.
#14
Registered
VIP Member
#15
Registered
VIP Member
I went by Pates Ford on the side of the boat! We went from damn to damn in 45mins. My chit was on the rug and Eric's was turning about 3500 rpm running 90. That is the best way I know to test your boat is to run around all day long with him. I thought about going up in pates.....but I figured you and bin laden were back there for a reason....
#18
Platinum Member
Platinum Member
Eddie built me 2 naturally asperated 600CI 750hp motors in 04 for my 4300 V Nortech. They were flawless, never had a problem with them. I will be having Eddie rebuild another set as well as some rigging for my inboard fishing vessel over this winter. The guy is honest, fair, which is very hard to come by in this industry. Jeff
Thread
Thread Starter
Forum
Replies
Last Post
Young Performance
General Boating Discussion
78
11-09-2006 08:45 AM
Pwrbt33
General Boating Discussion
1
10-04-2006 11:02 AM