Need a Gen 6 502 block
#1
VIP Member
Thread Starter
![Default](/forums/images/icons/icon1.gif)
I need a gen 6 502 block. Any suggestions?? I would take a complete 502 Mag MPI motor or a 500 Hp EFI motor if the price was right.
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
#2
Registered
#3
VIP Member
Thread Starter
![Default](/forums/images/icons/icon1.gif)
JC,
I can sleeve what I have, but I don't want to do that since I run a blower. I am already .030 over with a bore of 4.500. How much would it raise my comp. ratio if the block is milled .030 ??
Thanks,
Smitty
I can sleeve what I have, but I don't want to do that since I run a blower. I am already .030 over with a bore of 4.500. How much would it raise my comp. ratio if the block is milled .030 ??
Thanks,
Smitty
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
#4
Registered
Thread
Thread Starter
Forum
Replies
Last Post
Rockfish71
General Q & A
4
05-29-2008 01:39 PM