Hydro Lock
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Boca Raton Florida
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
Hydro Lock
Sh--!!!! Starter went THUNK!!!! Pulled plugs. #4 hole full of water. Cranked engive over to blow water out. Put plugs back in, engine ran fine! 2 days later, THUNK! pulled #4, water again. Engine is 540 BBC with IMCO exhaust. Any suggestions before I start pulling parts off?
#8
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Boca Raton Florida
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
That makes sense. With the angle of the engine the water ends up in #8 hole..... going to pull the riser and see if it's round or oval then order one from Imco.
#9
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Boca Raton Florida
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
Exhaust pulled and pressure tested. Imco manifold and riser is good. Pulling intake manifold Sunday. Sure hope I find a blown gasket.