Diamond Plate Planning and Installation?
#11
Banned
That's the finish I'm looking for nocigarette - how do you get to the drive and plane pumps?
I'm into a twin bay design and not sure if I want to hide the 4 pumps - maybe I'll make some plexiglas hatches so i can still see them - or mount them to the plate. I could use a link to some pics, to give me some solutions others have tried.
I'm into a twin bay design and not sure if I want to hide the 4 pumps - maybe I'll make some plexiglas hatches so i can still see them - or mount them to the plate. I could use a link to some pics, to give me some solutions others have tried.
#12
Registered
Thread Starter
Join Date: Sep 2007
Location: Toronto, Canada
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
Hide my stuff????
Yes, I would like to see the pumps and reservoirs but don't want them covered in engine sweat, so I'll probably clad the entire bay, mount the hydraulics, etc. onto the side verticles, fish the lines to keep the clutter out of sight, and bulkhead the sides with hinged 1/4" plexy panels.
I don't know about your chit, but mine doesn't stink, and I'm a closet exhibitionist trying to get found out......
#13
Registered
Thread Starter
Join Date: Sep 2007
Location: Toronto, Canada
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
Nice finish
Yes, I agree with you and Steel, it has to be as maintenance free as the existing finish, or it's a make -work project I don't need. I really like what you've done - do you ahve any more pics of your engine bay?
#17
Banned
Join Date: May 2007
Posts: 681
Likes: 0
Received 0 Likes
on
0 Posts
I just purchased diamond plate to do the engine compartment in my velocity. My plan was to clear coat the pieces, place a small bead of silicone around the edges, on the bottom of course, in order to keep water from seeping underneath and hold down with stainless wood screws and marine tex
Thread
Thread Starter
Forum
Replies
Last Post
Donzi Corleone
General Boating Discussion
8
06-10-2008 07:59 AM
bryanspeedracer
General Boating Discussion
18
08-12-2004 12:47 PM