632 Heads And Cam Questions
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Townsville Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
632 Heads And Cam Questions
Doing a 632 9:1 compression.Is this a good cam choice ?Hydraulic roller, 248* in and 258* @.050" and .647" lift.Leaning towards Edelbrock Victor senior heads.Do these compare with Dart Pro 1's ?
#4
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Townsville Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
#5
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Townsville Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
I want a motor that will idle like a 454 MAG but with the balls of a space shuttle.That cam has already been selected but the heads, i can get whatever i want,just want to make the right choice.Couldn't find much info on the Victor heads...Remember the space shuttle bit..
#7
i run a 598 with a 254 /260 575 on a 109.5 10 t0 1 fully ported polished dart pro one heads and ony make 700 and 7 70 tq 5600 rpm. i dont see making that power with that cam , the extra lift might make a little more but not much imo max tq was at 4500 rpm the lower lift will help with valve train longevity i hope
#8
Registered
Platinum Member
If it were me though. I would use something in an AFR, CNC'd, whatever is close to a 340 runner that they build. Consider some more lift on the cam and go with a solid roller.
Those engines could make serious space shuttle torque. close to 900 or better on carbs if you set them up right.
#10