Thunderbolt IV & Crane Box question
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
I have the T-Bolt IV distributor and a Crane HI-6M box. The place I got the box from included a 35 degree phased rotar, for a fee of course. The metal wheel is so far off that it rubs on the sensor in the distributor
So, I tried moving my old rotor on the wheel 35 degrees, and didn't do much better ![Roll Eyes (Sarcastic)](/forums/images/smilies/rolleyes.gif)
Question is ..... Anyone know of a place that sells/supplies rotors for the T-Bolt IV distributor, already set up/degreed for the Crane box. ?
Thanks
![Mad](/forums/images/smilies/mad.gif)
![Roll Eyes (Sarcastic)](/forums/images/smilies/rolleyes.gif)
Question is ..... Anyone know of a place that sells/supplies rotors for the T-Bolt IV distributor, already set up/degreed for the Crane box. ?
Thanks
#2
Registered
![Default](/forums/images/icons/icon1.gif)
I drilled my own several years back. Use the template found in the PDF doc from Crane. Center punch and start with small drill bit. I don't recall it being an issue. Once it is done you can reuse the wheel, it is a non wear item.
#3
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Thanks BadDog