IMCO inner transom plate conflicts with steering lever?!
06-19-2008, 09:06 AM
#1
Registered
Thread Starter
Join Date: Jul 2004
Location: Stockholm, Sweden
Posts: 1,229
Likes: 0
Received 0 Likes
on
0 Posts
IMCO inner transom plate conflicts with steering lever?!
I just found out that my inner transom plate is broken and needs to be replaced (Bravo). I found IMCO's HD one MB-12-N but it seems it would conflict with the steering lever.
Is there any way to remove the steering lever and replace it with some sort of spacer instead?
I have always hated to see that unused lever but never really had any reason to remove it.
There is another pic of the transom plate in the may edition of Powerboat Mag page 57 (Rigging of an Eliminator 27 Daytona).
Is there any way to remove the steering lever and replace it with some sort of spacer instead?
I have always hated to see that unused lever but never really had any reason to remove it.
There is another pic of the transom plate in the may edition of Powerboat Mag page 57 (Rigging of an Eliminator 27 Daytona).
Last edited by tomas_wallin; 06-19-2008 at 09:39 AM. Reason: may - not june...
06-21-2008, 07:02 AM
#3
Registered
Just whack it off .......The lever that is .....
but when you do ..... remember the lever is steel ......all those fillings will rust ...make sure you catch em or clean em out ....m
but when you do ..... remember the lever is steel ......all those fillings will rust ...make sure you catch em or clean em out ....m
Last edited by offthefront; 06-21-2008 at 07:08 AM.
06-30-2008, 02:56 AM
#4
Registered
Thread Starter
Join Date: Jul 2004
Location: Stockholm, Sweden
Posts: 1,229
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
eliminator25
Drives and Lower Units
4
05-08-2008 04:37 PM
