Go Back  Offshoreonly.com > Technical > General Q & A
496 Air Actuator Problem >

496 Air Actuator Problem

Notices

496 Air Actuator Problem

Thread Tools
 
Old 04-22-2009, 11:25 AM
  #1  
Registered
Thread Starter
 
Join Date: Apr 2009
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default 496 Air Actuator Problem

Have a 2002 496 mag. The port side air actuator drain system opens at 3000rpms and higher filling the bilge with water. Pull up on the release valve and the system closes for a few seconds, but then reopens. Any ideas or help?
ptellers is offline  
Old 04-22-2009, 11:44 AM
  #2  
Forum Regulator
VIP Member
 
Sydwayz's Avatar
 
Join Date: May 2001
Location: Worldwide
Posts: 23,878
Received 1,251 Likes on 544 Posts
Default

They just go bad after a while; it's happened to many of them. It needs replaced. You can rebuild them, but your money and efforts are better spent just replacing it.

www.bammarine.com
www.dolleroffshore.com

Either can get you the part. It only takes about 30 minutes to replace if you can get to it, and you have a good set of (normal) tools.
Sydwayz is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.