hynautic cylinders
#1
Registered
Thread Starter
Join Date: Jul 2007
Location: lorain,ohio
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
anyone know the cu inch volume of the k-5b cylinders? trying to figure turns end to end with h42-02 helm which is 4.0 cu inch////////////////thanks in advance
#2
Registered
Join Date: Dec 2006
Location: Merritt Island, FL
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Not sure, but maybe this spreadsheet will help what you're trying to do. I am looking at swapping over to a full hydraulic as well and wanted to figure some system parameters.
The spreadsheet makes some gross assumptions but in a single plane, the math should work. I could do a lot better in ProE.
Randy
The spreadsheet makes some gross assumptions but in a single plane, the math should work. I could do a lot better in ProE.
Randy
Last edited by bustedbrick; 09-13-2011 at 09:22 PM.
#3
Registered
Thread Starter
Join Date: Jul 2007
Location: lorain,ohio
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Not sure, but maybe this spreadsheet will help what you're trying to do. I am looking at swapping over to a full hydraulic as well and wanted to figure some system parameters.
The spreadsheet makes some gross assumptions but in a single plane, the math should work. I could do a lot better in ProE.
Randy
The spreadsheet makes some gross assumptions but in a single plane, the math should work. I could do a lot better in ProE.
Randy
#5
Registered
![Default](/forums/images/icons/icon1.gif)
The one you are looking at in th swap shop has 2 cylinders so it would be 8 turns lock to lock.
I am running a hynautic system on my boat right now and it is 8 turns. I don't mind it but I have twins so I can turn by using forward and reverse. On a single that would be a pain in the a$$.
I guess if you just used a single cylinder it would be ok.
I am running a hynautic system on my boat right now and it is 8 turns. I don't mind it but I have twins so I can turn by using forward and reverse. On a single that would be a pain in the a$$.
I guess if you just used a single cylinder it would be ok.
Last edited by Rookie; 11-29-2009 at 12:15 PM.
#6
Registered
![Default](/forums/images/icons/icon1.gif)
The K5s are unbalanced. The volume of the rod takes up some volume on one side. So that number wont be exact.
As was ponited out, 2 cylinder would be about 2X the volume, but it would be a balanced etup, so at least turns to lock would be the same in both directions.
As was ponited out, 2 cylinder would be about 2X the volume, but it would be a balanced etup, so at least turns to lock would be the same in both directions.