water pressure tubing
#2
Registered
![Default](/forums/images/icons/icon1.gif)
Most gauge kits use 1/8" poly tubing. You can buy the tubing and fittings from any hardware store. I don't like the tubing so I use 1/4" rubber hose. You can use either fuel hose, or a more specific hose like push-loc hose from Russel, Earl's. Aeroquip, etc. You can order it from Summit or Jegs, etc.
You can also order a full kit from Livorsi with the gauge and the tubing and fittings.
Eddie
You can also order a full kit from Livorsi with the gauge and the tubing and fittings.
Eddie
#3
Registered
Join Date: May 2004
Location: Okanagan Falls BC. Canada
Posts: 596
Likes: 0
Received 1 Like
on
1 Post
![Arrow](/forums/images/icons/icon2.gif)
I use Pisco tubing, since we have them at work in various sizes. 1/8 is the sizeyou need.
http://www.pisco.com/category.aspx?catid=12
http://www.pisco.com/category.aspx?catid=12
#5
Charter Member # 55
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
The plastic tubing likes to kink pretty easily. If you use it, leave a couple extra feet coiled up, especially if you use teh block drain to feed it. The tubing can clog and it is sometimes easier to cut off a few inches than to try and unclog it.
#6
Registered
![Default](/forums/images/icons/icon1.gif)
I found some 1/4 inch air hose at The Home Depot .It is gray in color . It came in a 50' roll for about 35 dollars.
Last edited by 737jetmech; 12-10-2009 at 12:24 PM.