What all would take out a coupler?
#22
Registered
Join Date: Jun 2010
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
keep me posted as well cause nobody has an answer for me , i really dont feel like doing this a third time! what coupler part number did you install and on what drive and motor, mine is a XR on a 525efi. both times it happened to me i just finished passing a big cruisers wake but my mechanic swears everything is tight and nothing is moving, but my top gears are finished,need to be rebuit
#23
Registered
Thread Starter
Join Date: Jun 2003
Location: Amherst Ohio
Posts: 686
Likes: 0
Received 0 Likes
on
0 Posts
Our problems are a little different as my gears still look brand new. If yours are blue that would be a sign of excessive heat. So i would guess there is something wrong inside your drive. From what I can tell most of my internals don't show any problems that would cause teh drive to lock up.
I will keep you posted though as to what I find out.
Mine is a 600SC connected to a XR drive.
I will keep you posted though as to what I find out.
Mine is a 600SC connected to a XR drive.
#24
Registered
Join Date: Jan 2009
Location: TEXAS
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Is this the post your talking about. This is what happen to me.
http://www.offshoreonly.com/forums/g...p-coupler.html
http://www.offshoreonly.com/forums/g...p-coupler.html
OK, long shot, but I seem to recall reading something about HP couplers requiring somewhat of a different process over stock when putting the motors in. Wish I could remember the thread. That is the only thing I haven't seen mentioned already. Hope that helps, I'm out of suggestions.
#25
Registered
Yes
#27
Geronimo36
Gold Member
Are you running the HP Couplers with steel splines and snout or the standard coupler with aluminum splines? If it's the rubber maybe you just got a bad coupler. Seem's odd to me, I'd have to see it in-person.
I blew a coupler once in my 36' and the only reason that happen is because I blew a drive and it locked up but that was before I got the BMax drives. Matter of fact, the coupler didn't actually blow, I ran it the following weekend and replaced it the weekend after that because the rubber was starting to fall out. I'm running the HP couplers with steel splines on 800+ hp..
Have you checked the gimbal rings for excessive wear/play?
I blew a coupler once in my 36' and the only reason that happen is because I blew a drive and it locked up but that was before I got the BMax drives. Matter of fact, the coupler didn't actually blow, I ran it the following weekend and replaced it the weekend after that because the rubber was starting to fall out. I'm running the HP couplers with steel splines on 800+ hp..
Have you checked the gimbal rings for excessive wear/play?
#28
Platinum Member
Platinum Member
Mine had the steel splines. The rubber is what exploded & took out the rear mount and wye pipe. Lucky it happened close to shore so we could paddle in before sinking.