B&M Blower service and Holley carb refinish
#1
Registered
Thread Starter
B&M Blower service and Holley carb refinish
Where to send B&M blowers for service and repair with warranty? (B&M itself?) I didn't see blowers listed on their site... I found no PN stamped on the blower???
Where to send Holley 650s for a dip (Cleaning) and refinish/plating?
4 carbs PN-4777-4 2433 (650 cfm). Is it cheaper to buy new?
These are off of a Hawk 575 package, 1990 vintage, blowers were upgraded from??? Twin engine, 454 cu. Merc original engines with the the smaller blower package from Cig.
Where to send Holley 650s for a dip (Cleaning) and refinish/plating?
4 carbs PN-4777-4 2433 (650 cfm). Is it cheaper to buy new?
These are off of a Hawk 575 package, 1990 vintage, blowers were upgraded from??? Twin engine, 454 cu. Merc original engines with the the smaller blower package from Cig.
#2
Registered
Was just down to DMPE. Seem to be really good people and know their stuff. Give them a call.
http://www.dmpeinc.com/
http://www.dmpeinc.com/
#3
Registered
Chances are you have the B&M 250 Series blowers. I would send them to the blower shop for rebuilds.
http://www.theblowershop.com/category/20
http://www.theblowershop.com/category/20