K-Plane Pin!!! Stuck!!
#1
Platinum Member
Platinum Member
Thread Starter
K-Plane Pin!!! Stuck!!
Taking my K-Plane Plates off. One came off easy. The long pin on the other plate won't move a bit.. Need Ideas on getting it out! Thanks Scott
Last edited by SKRAMER; 04-22-2011 at 06:42 AM.
#2
Registered
Join Date: Oct 2005
Location: MCHENRY,IL
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Nice pic....
If your serious try a heat gun first hot but not cooking the paint like a torch. Next a simple torch propane no map gas. Heat it up and drive a pin through make sure no one put an e clip in the hinge. It will barely be noticeable if they did.
Next take the whole unit of and press it out with a ten ton press. Done a few but it is usually the eclip.
If your serious try a heat gun first hot but not cooking the paint like a torch. Next a simple torch propane no map gas. Heat it up and drive a pin through make sure no one put an e clip in the hinge. It will barely be noticeable if they did.
Next take the whole unit of and press it out with a ten ton press. Done a few but it is usually the eclip.
#3
Charter Member #232
Charter Member
Best thing you can do it to take them cut the pin between each area on the tab that you can get to. Then you can remove the smaller pieces a lot easier.
__________________
Put your best foot forward!
Put your best foot forward!