Camshaft Identification help
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
I have a comp cams hydraulic roller for BBC, just don't know any specs on it. I want to get rid of it as I do not need it but can't find the cam card.
On the end I believe I am reading the following:
3120b-3372B
HR112
F9560-05
Any help is greatly appreciated.
On the end I believe I am reading the following:
3120b-3372B
HR112
F9560-05
Any help is greatly appreciated.
#2
MarineKinetics
![](https://www.offshoreonly.com/forums/images/icons/platinum_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
304º/314º @ .006"
244º/258º @ .050"
161º/175º @ .200"
.383"/.380" Lobe
.651"/.646" 1.7 RR
112º Sep +4º
244º/258º @ .050"
161º/175º @ .200"
.383"/.380" Lobe
.651"/.646" 1.7 RR
112º Sep +4º
Last edited by rmbuilder; 02-25-2012 at 04:09 PM.
#3
Registered
![Default](/forums/images/icons/icon1.gif)
what are you asking for it?
#4
Registered
![Default](/forums/images/icons/icon1.gif)
thanks for the pictures,the cam is for a gen6 engine,i need one for mark4.
#6
Registered
![Default](/forums/images/icons/icon1.gif)
the picture,it appears to be a bullet nose,the nose on mark4&gen5 have a flat nose..
#8
Registered
![Default](/forums/images/icons/icon1.gif)
at the front ,where the timing chain bolts on,the dia is smaller about .250 deep,this is so the retainer plate can control rearward movement,only gen 6 cam has this.it is often refured to as a[ bullet nose]i may be wrong,but that is the way it looked in the picture you sent me.