Sea/Fuel Pump Pulley Question
06-23-2002, 03:15 PM
#1
Platinum Member
Platinum MemberThread Starter
Join Date: Mar 2001
Location: Sebring, FL, USA
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Sea/Fuel Pump Pulley Question
OK everyone... Here goes the dumb question of the day... I would like to know the removal process for the pully on the Raw Water/ Fuel Pump assemble... It looks as though this is a puller scenario, however, I thought I had better ask the experts who may have done this before in hopes of avoiding mistakes which I sometimes make by "just doing it"... The application is a Mercruiser 525SC but I would imagine this to be a typical late model Mercruiser application across the board... Just want to blast, prime and repaint and any help would be greatly appreciated...
Tnx, Karl
Tnx, Karl
06-24-2002, 01:01 AM
#3
Ginger or Mary Ann?
Charter Member
If you have an Auto Zone store, they will rent the puller/installer for free. Been there, Done that.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
06-24-2002, 08:40 AM
#4
Platinum Member
Platinum MemberThread Starter
Join Date: Mar 2001
Location: Sebring, FL, USA
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys...
I have a puller but just wanted to make sure that it was the proper method... Just a press fit back on over the key? Once
again... Thanks much...
Karl
I have a puller but just wanted to make sure that it was the proper method... Just a press fit back on over the key? Once
again... Thanks much...
Karl
No key
VIP Member
06-25-2002, 08:55 AM
#7
Platinum Member
Platinum MemberThread Starter
Join Date: Mar 2001
Location: Sebring, FL, USA
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys... This would imply that I will need to disassemble the unit out of the boat so that a press can be used... I may not like the news but thanks much for the information...
Karl
Karl
