502 carb 550hp - Blower vs NA
#1
Registered
Thread Starter
502 carb 550hp - Blower vs NA
I know there have been plenty of "NA vs Blower" threads and I have searched them. But, I would like to hear opinions from the gearheads on here about this specifically.
If you had a 502 Mag (carb version) and you wanted 550hp, would you replace the cam, lifters, pushrods, rockers, springs, intake, carb and exhaust or look at putting a small blower (420 or similar) blower on top with upgraded head bolts/studs, head gaskets and valves?
Which is more cost effective and reliable at this moderate hp level?
If you had a 502 Mag (carb version) and you wanted 550hp, would you replace the cam, lifters, pushrods, rockers, springs, intake, carb and exhaust or look at putting a small blower (420 or similar) blower on top with upgraded head bolts/studs, head gaskets and valves?
Which is more cost effective and reliable at this moderate hp level?
#4
Registered
This kind of mirrors my thinking, decent cam, above average heads, what can a guy expect?
edit in ; I have zero room to get taller than the current stock setup.
edit in ; I have zero room to get taller than the current stock setup.
Last edited by buck35; 07-16-2015 at 10:14 PM.
#5
Registered
Thread Starter
550 hp is obtainable with either, but I agree the delivery will be different. I was looking at getting there NA, and the costs add up quick. Which got me thinking, would it be cheaper and easier to pick up a used blower and go that route.
No right or wrong, just looking for opinions.
No right or wrong, just looking for opinions.
#7
Registered
i think what rookie is saying is if you go with a 420 blower you will be way over 550 hp.i am a blower guy but only you can decide what is best for you.the n/a build will not make the torque a blown deal will make but that will extend your drive,s life.what ever direction you choose to go you will need to upgrade to a good exhaust system,change cam&components,either replace the heads or at least have your heads worked,buy a carb or two,etc.if i wanted only 550 hp i would go n/a.
Last edited by mike tkach; 07-17-2015 at 05:52 PM.
#8
Registered
The blower deal will probably make a little more EGT and thus be a little harder on your exhaust valve seats / valves, and etc.
Maybe better to change to a better (thicker head if cast iron) and new aftmkt head with attention to detail from a cyl head guy with thicker seat margins and etc.
Anyway, a cast iron RHS, Engine Quest, Dart head with with a mild cam will put you at that.
A stock head with '731 cam will put you just under that.
=================================================
550 HP doesn't sound like much in todays world. But that's in comparison.
But, reality says it is still 550HP...which is, well, a lot.
Maybe better to change to a better (thicker head if cast iron) and new aftmkt head with attention to detail from a cyl head guy with thicker seat margins and etc.
Anyway, a cast iron RHS, Engine Quest, Dart head with with a mild cam will put you at that.
A stock head with '731 cam will put you just under that.
=================================================
550 HP doesn't sound like much in todays world. But that's in comparison.
But, reality says it is still 550HP...which is, well, a lot.