I know it has been beat to death but ... hydraulic roller lifters ??
#21
Platinum Member
Platinum Member
I think their fine for stock rebuilds as stated OE replacement ..........but if your running a more aggressive cam profile you might want to look at others
#22
Registered
So what kind of profiles have put these to the test with good or bad results. I need to replace my new solids for .300 lifters. Are Isky red zones still near the top or are the hy-lift Johnsons doing well also?
I will have two sets of new solid severe duty crowers on the swap.
I will have two sets of new solid severe duty crowers on the swap.
#25
Registered
I was going to go with these until Comp said there was no need to replace my solids on their HR HUC lobes and my Red Zones were a good match.
http://www.iskycams.com/downloads/LSSemaFinal.pdf
The UPS man just dropped off my rebuilt Red Zones today.
http://www.iskycams.com/downloads/LSSemaFinal.pdf
The UPS man just dropped off my rebuilt Red Zones today.
#26
Registered
I talked to jv today and ya... The world of lifter is about as confusing as the real world. All seems to intertwine and somehow get back ttt. "1"
I didn't see the plus .300 SR bush on website?
I didn't see the plus .300 SR bush on website?
Last edited by getrdunn; 01-25-2021 at 09:00 PM.
#28
Registered
I want to get some Yella Terras, but when I went to pull the trigger on them they had to build some 1.75's because they aren't a shelf item. It gave me too much time to think about it. I figured rockers were the least of my worries. I will probably still pull the trigger on them eventually.
The following users liked this post:
getrdunn (01-25-2021)