350 Mag MPI
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Oct 2003
Location: Townsville Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
350 Mag MPI
Just got a 350 Mag serial number OW002492.
There is no wiring to the distributor.Looks like it should take a plug,maybe 3 wire.
There is no wiring to the distributor.Looks like it should take a plug,maybe 3 wire.
#2
Banned
early version did not use it... its the cam sensor and not used because the fuel injectors were batch fired -- BUT later versions DID PLUG into the cam sensor as it was USED ----- to end up firing the fuel injectors in semi batch fired.
All this goes by engine serial number when it was NOT used and when it WAS used. I would have to run your serial number when I get a chance to if it was or not used.
Very specific info that is not in the service manuals either nor out there.
All this goes by engine serial number when it was NOT used and when it WAS used. I would have to run your serial number when I get a chance to if it was or not used.
Very specific info that is not in the service manuals either nor out there.
Last edited by BUP; 01-25-2020 at 12:04 AM.
#4
Banned
the correct answer is no plug into the HVS period... That's because you have the early version set up and earlier ecm 555 calibration, Persay the lessor EC requirements to be met for the EPA standards here in the USA for that build timeframe..
Last edited by BUP; 01-25-2020 at 04:17 PM.