Webster stud girdles with Keith Eckerd 2pc valve covers
03-09-2020, 11:49 AM
#11
Platinum Member
Platinum Member
what are webster???
rock shaft system?
or its a stud girdle system....
i had jomars on my super gas car...
again i was going to put stud girdle on my motors, and engine builder said , i dont need and stud girdle are tuff on aluminum heads
my isky cams are 714 lift,,,dont know spring pressure.
rock shaft system?
or its a stud girdle system....
i had jomars on my super gas car...
again i was going to put stud girdle on my motors, and engine builder said , i dont need and stud girdle are tuff on aluminum heads
my isky cams are 714 lift,,,dont know spring pressure.
03-09-2020, 11:49 AM
#12
Registered
Platinum Member
Can I make the Keith Eckard two piece valve covers work with Webster stud girdles and have enough clearance with the three-quarter or 1 inch valve cover spacers does anybody have any experience with it? Motors are
world block low decks and world heads
cmi etop exhaust with roller rockers
looking to add space for Webster girdle
doable ?
world block low decks and world heads
cmi etop exhaust with roller rockers
looking to add space for Webster girdle
doable ?
we have same exhaust i think.
maybe time to look at stud girdle ......
jomar is another brand,,ran jomar setup before on super gas car.
Last edited by flashgordon; 03-09-2020 at 11:50 AM. Reason: info
03-09-2020, 05:17 PM
#13
Registered
Platinum Member
so,,,,??????
yes sorry to hijack OP thread also...
Last edited by flashgordon; 03-09-2020 at 05:19 PM. Reason: info
