Holley HP EFI conversion
#221
Registered
Available at Summit too:
https://www.improvedracing.com/remot...t-env-170.html
#222
Registered
This is a picture from the outside, there is another building here now.
The following users liked this post:
Rookie (01-25-2021)
#224
artselectricinc.com
Platinum Member
Have a look this converter box built by one of our members. I purchased two of them to interface with a Garmin 7212. Data from both engines show up on chartplotter in any weather. Installed them about five years ago, and are still working fine.
converter box for nmea 2000
Steve
converter box for nmea 2000
Steve
#225
Registered
Why the new lifters?
#226
Registered
Thread Starter
I sent them out to Isky to be rebuilt. They have been in the engine since 2006 and they were rebuilt at that time. Just added security. I have 3 sets and the ones I put in the engine came out of an engine with half the time on them. I didn't think I would get them back so soon. I swapped them out last night. All good.
I only want to be waxing paint and polishing stainless steel over the next 5 yrs.
I only want to be waxing paint and polishing stainless steel over the next 5 yrs.
The following 3 users liked this post by Rookie:
#227
Geronimo36
Gold Member
Was reading about the issue you had with the IAC. I had the same exact problem on the engine I posted a few weeks ago. IAC was opening instead of closing... had to repin it and then I was good to go. Too funny!!! Definitely threw me for a loop at first.
The following 2 users liked this post by Panther:
articfriends (01-29-2021), Rookie (01-28-2021)
#228
Registered
they were primarily used and many sold from Quonset Air Force base. It’s a Rhode Island industrial park now. I work there 3-4 days p/week
The following 2 users liked this post by Unlimited jd:
articfriends (01-29-2021), SB (01-28-2021)
#230
Registered
I only check in here every couple weeks or so these days and I’m always like, “I’m sure Rookie has that **** sorted out by now”. Lol
Keep up the good work! One of the most enjoyable threads atm.
Keep up the good work! One of the most enjoyable threads atm.
The following 3 users liked this post by Baja Rooster: