Pair of 2007 525efi flop at same time
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
So, was out for a spin yesterday, boat ran great, then found a spot to anchor off for 1.5hrs. TX temp was 95. Anchor up, idling out, past the markers, throttle down, and about 3000 rpm I hear a pop or click, and both engines nearly die. I pulled back throttle and shut them off. Tried to restart, wouldn't. Would crank, sputter, die. Both engines identical issue. Wonder if vapor lock, over and hour later, same. Got towed in. 85 gallons of fuel on board from March with Chevron Marine stabilizer in.
This morning I put in 12 gallons fresh fuel, back to ramp, once primed and started,, both engines idling fine. Smartcraft showing NO codes. Electric fuel pump working when key turned, etc hear it run. All looks and seems normal. Fuel psi at idle is 40psi and 43psi.
Fuel/water separator was changed Aug 2018, 35hrs ago to today. Will change those agin before next time out. Fuel Filter element is due in 9 more hours when I hit 200hrs. Mechanical Fuel pump fluid changed often, last done Sept 2020, 16 engine hrs ago.
Seems since both engines acted the same, had to be a common source, ie incoming fuel.
Other thoughts???
This morning I put in 12 gallons fresh fuel, back to ramp, once primed and started,, both engines idling fine. Smartcraft showing NO codes. Electric fuel pump working when key turned, etc hear it run. All looks and seems normal. Fuel psi at idle is 40psi and 43psi.
Fuel/water separator was changed Aug 2018, 35hrs ago to today. Will change those agin before next time out. Fuel Filter element is due in 9 more hours when I hit 200hrs. Mechanical Fuel pump fluid changed often, last done Sept 2020, 16 engine hrs ago.
Seems since both engines acted the same, had to be a common source, ie incoming fuel.
Other thoughts???
#2
Platinum Member
![](https://www.offshoreonly.com/forums/images/icons/platinum_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
next time when anchoring leave the hatch up a couple feet, I think you had heat soak V lock
The following 3 users liked this post by F-2 Speedy:
#3
VIP Member
![](https://www.offshoreonly.com/forums/images/icons/prop.gif)
![Default](/forums/images/icons/icon1.gif)
I know you said you had fuel stabilizer in but...sounds an awful lot like phase separation in ethanol blended fuel...? I mean for BOTH engines to experience essentially the same failure at the same time?
__________________
Baja 252 Islander
Baja 252 Islander
#4
Registered
![Default](/forums/images/icons/icon1.gif)
Your engines would love you if you changed the water separator and filters annually - cuts down on a lot of issues and filters/services should be based on # of hours or "x" months in the same year.
The following 3 users liked this post by speicher lane:
#5
Registered
#6
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Thank you all. Merc Racing said same about annual water fuel separator change. Also, when I pull the current ones off, pour into a jar and see how much of each separates out....
Will keep you guys posted...
Will keep you guys posted...
The following users liked this post:
bajaman (06-14-2021)
#7
Forum Regulator
![](https://www.offshoreonly.com/forums/images/icons/prop.gif)
![Default](/forums/images/icons/icon1.gif)
Replace fuel water separators at the start of EVERY season.
The following 4 users liked this post by Sydwayz:
#8
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Once I pull the fuel/water separators off, if I find too much water to be the case, what have others done (besides drain the enter tank somehow), to help remedy? I have about 90 gallons from March in there, and 10 gallons from yesterday, for a total of 100 gallons in the tank today.
Thx
Thx
#9
Forum Regulator
![](https://www.offshoreonly.com/forums/images/icons/prop.gif)
![Default](/forums/images/icons/icon1.gif)
Once I pull the fuel/water separators off, if I find too much water to be the case, what have others done (besides drain the enter tank somehow), to help remedy? I have about 90 gallons from March in there, and 10 gallons from yesterday, for a total of 100 gallons in the tank today.
Thx
Thx
#10
Registered
![Default](/forums/images/icons/icon1.gif)
If 85 gallons of fuel from March of this year with stabilizer is giving you issues (separation, too much water, or whatever) I'd be totally surprised.
I'm doubtful there's any issues with the fuel.
I'm doubtful there's any issues with the fuel.