Mercury wiring
#1
Registered
Thread Starter
Join Date: Sep 2015
Location: Oklahoma
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Mercury wiring
Looking for help on wiring. I have been on the phone with mercury and they have been great help although no luck. I have the 14 pin wiring in my boat and motors that were installed are the old school 9 pin. So bought the adapters from mercury and it should work but I am not getting tach reading and oil pressure. I have checked all the wires and have no breaks everything ohms correct
gauges work. And sending units work but nothing is talking to each other.
I can’t be the only one that has done this any help would be great.
gauges work. And sending units work but nothing is talking to each other.
I can’t be the only one that has done this any help would be great.
#2
Registered
Been many that have had the same issue and don't know of one which posted the solution. I have the pin out which may help
The following 2 users liked this post by AllDodge:
SabrToothSqrl (07-08-2022), TomZ (07-08-2022)
#3
Registered
You need this: https://www.greatlakesskipper.com/me...SABEgJ2-PD_BwE
I have a couple on the shelf if you don't mind used.
*EDIT*
I may have misunderstood your issue. What engines are you installing, and what gauges are in the boat?
I have a couple on the shelf if you don't mind used.
*EDIT*
I may have misunderstood your issue. What engines are you installing, and what gauges are in the boat?