Cam upgrade?
#11
Guest
Posts: n/a
![Default](/forums/images/icons/icon1.gif)
Hello, Guys!
Most all hydraulic roller lifters are made by the same company so there is no real difference in any brand.
Solid rollers are made by a few different manufacturers-Isky and Crower being the ONLY ones we use. No other brand we have tried will live like these-no matter whether they have bearing oiler provisions or anything else. Of course, you can break anything, and ANY valve float will destroy ANY lifter quickly!!!
Too much spring pressure shortens valve train life also. Be wary and always set up the valve train as recommended by the manufacturer!!
Most all hydraulic roller lifters are made by the same company so there is no real difference in any brand.
Solid rollers are made by a few different manufacturers-Isky and Crower being the ONLY ones we use. No other brand we have tried will live like these-no matter whether they have bearing oiler provisions or anything else. Of course, you can break anything, and ANY valve float will destroy ANY lifter quickly!!!
Too much spring pressure shortens valve train life also. Be wary and always set up the valve train as recommended by the manufacturer!!
![Big Grin](/forums/images/smilies/biggrin.gif)
#13
Guest
Posts: n/a
![Default](/forums/images/icons/icon1.gif)
Hi Carreraboat!
I usually just check the rollers for proper, smooth, no-slop roller operation. If they feel good, use them! The fuel pump pushrod problem is not too common, but you probably used a stock type fuel pump pushrod on a steel roller cam. This is repairable, but not practical as you have to pull the cam and send it back to the factory to be welded and reground. I usually install a good electric pump or use a Mercruiser raw water pump for the Mark V
block. It has a fuel pump provision on it.
To avoid the problem in the future, special fuel pump pushrods are available with bronze tips for this application. They are available from most speed shops or mail order-like Summit or Jegs.
Good luck and if you need further info or I can help in any way, pm
1
I usually just check the rollers for proper, smooth, no-slop roller operation. If they feel good, use them! The fuel pump pushrod problem is not too common, but you probably used a stock type fuel pump pushrod on a steel roller cam. This is repairable, but not practical as you have to pull the cam and send it back to the factory to be welded and reground. I usually install a good electric pump or use a Mercruiser raw water pump for the Mark V
block. It has a fuel pump provision on it.
To avoid the problem in the future, special fuel pump pushrods are available with bronze tips for this application. They are available from most speed shops or mail order-like Summit or Jegs.
Good luck and if you need further info or I can help in any way, pm
1