Paging John B:sideways carb mount ?
#3
Registered
Thread Starter
Join Date: Oct 2002
Location: Cape Coral,Fl.
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
RLW,
I was going to use a 4150 hp series 1000 cfm which the base is not "square". I did not realize the 4500 base bolt pattern is square.I'm sure fabricating a plate for what I'm trying to do would'nt be to hard,just thought maybe someone made a adapter " turn" a 4150.
I was going to use a 4150 hp series 1000 cfm which the base is not "square". I did not realize the 4500 base bolt pattern is square.I'm sure fabricating a plate for what I'm trying to do would'nt be to hard,just thought maybe someone made a adapter " turn" a 4150.
#4
Profile, I was using a 4500 1050cfm, which was a square bolt pattern. I don't know if anyone makes the adapter you need. You could probably get a standard adapter and move some of the studs! JB
#6
Jeff,
Try to stay away from the older single circuit dominators, they have to be set up to run rich all the time, unless you change the metering blocks. I think the blocks are about $100 each.
John B
Try to stay away from the older single circuit dominators, they have to be set up to run rich all the time, unless you change the metering blocks. I think the blocks are about $100 each.
John B