skegs
#1
Registered
Thread Starter
Join Date: Jul 2002
Location: Houston,texas
Posts: 1,387
Likes: 0
Received 0 Likes
on
0 Posts
skegs
who has the bent or broken skeg? one easy way to fix is to take a cut off wheel score a straight line 1/8 deep across and 1" or so below the bullet/then believe it or not take a big hammer and hit it hard with a good swing and SNAP It will break off straight off everytime /then purchase a SKEG GUARD ,USE THE SAME ADHESIVE that GM uses on there truck doors to hold them on ,it works and holds and off you go /no heat applied to the gearcase what so ever. or have it welded and finished back down by a local shop that is good or request a new aluminum skeg welded on and finished out to look new.just note that it will never be as strong as new as the aluminum always has porisity?(spell check) when heat is applied no matter how clean you prepare it /it 5:30a.m. I must be bored /Darin oh or just by a new housing.
Last edited by HOUSTONPROP; 02-01-2003 at 05:38 AM.
#2
Neno the mind boggler
VIP Member
hey . . as long as we are on the subject of scegs. what is meant by " herring skegs" on #6 drives. i think i saw the term used on a race boat being sold. just curious.
__________________
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
#4
Guest
Posts: n/a
I did a skeg gaurd last year and have some advise. Seal the area around the top. I didnt and it filled with drive oil the first time I changed the drive oil. Didnt realize it until I put the boat in the water. Thought I had a bad leak due to the huge oil slick behind me boat. I checked the whole drive over b4 figuring out what happened.
#5
Registered
Thread Starter
Join Date: Jul 2002
Location: Houston,texas
Posts: 1,387
Likes: 0
Received 0 Likes
on
0 Posts
I actually designed the skeg guard. had it on paper several years ago/I went to a convention and opened my mouth,of course ,I did not have the patent/next thing you know ,I lost it . I was up late one night drew it on paper and thats all the further I went other than opening my mouth.Darin
#8
I was wondering if the "skeg-guard" would cause any loss of speed or cause cativation? My skeg-guard has a tri-angle shaped plate on the bottom of it. Seems like some don't...What is the purpose anyways of this on the skeg-guard anyways...
#10
Registered
Thread Starter
Join Date: Jul 2002
Location: Houston,texas
Posts: 1,387
Likes: 0
Received 0 Likes
on
0 Posts
SKEGGUARD
When ,I designed my Skeg Guard it did not have this ,and when they came out this was the only difference. I assume its to act as a stabalizer?but it would think it would cause more drag than anything?Darin