What are the1995 500HP cam specs
#1
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
What are the1995 500HP cam specs
who made it and what was the part number I want to compare it to what my motor guy is recommending
Last edited by klaw; 03-10-2004 at 08:36 AM.
#2
Registered
It was [email protected] intake duration and [email protected] exhaust duration. It had approx .580 and .590 lift if I recall correctly. I believe it was ground on a 110 degree LSA, but it may have been 112LSA. I do know that they installed them slightly advanced in the HP 500.
It was made by crane but had a Merc #.
It was made by crane but had a Merc #.
#4
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
I think this is the guy I had the spec I just wanted to check it
Part Number: 169611
Grind Number: HR-284-2S-10 IG
Engine Ident: 1996-UP CHEVROLET V-8 454 THRU 502 CU.IN.
HYD. ROLLER WITH CAST IRON DISTRIBUTOR
DRIVE GEAR.
Part Number: 169611
Grind Number: HR-284-2S-10 IG
Engine Ident: 1996-UP CHEVROLET V-8 454 THRU 502 CU.IN.
HYD. ROLLER WITH CAST IRON DISTRIBUTOR
DRIVE GEAR.
__________________
Kept the Bullet and the condo and joined the cig 20 restoration club.
Kept the Bullet and the condo and joined the cig 20 restoration club.
#6
MarineKinetics
Platinum Member
#9
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
carb
__________________
Kept the Bullet and the condo and joined the cig 20 restoration club.
Kept the Bullet and the condo and joined the cig 20 restoration club.