What number drive is this?
#3
Registered
Thread Starter
Originally posted by Reed Jensen
It looks like a SSM IV or SSM V,... if you post the serial number I can tell you which one. I have the workshop manual.
It looks like a SSM IV or SSM V,... if you post the serial number I can tell you which one. I have the workshop manual.
#7
Gold Member
Gold Member
Join Date: Feb 2003
Location: Carlsbad, CA
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
You can tell the difference between 4 and 5 by the size of the pin that holds the lower trim ram. The pin goes all the way across the bottom of the gimble and holds both trim rams. If it is 7/8 inch thick then it is probably a 5. If it is smaller, it is a 4. Also, the prop shaft size will usually tell you but some of the #4's have had their shaft size upgraded. If it a small shaft then it is definately NOT a 5.
Agreed on the 2 inch spacer.
I think I got all this straight.
Agreed on the 2 inch spacer.
I think I got all this straight.
#8
Registered
Join Date: Dec 2003
Location: Los Angeles California
Posts: 8,306
Likes: 0
Received 2 Likes
on
2 Posts
Notice the short cavitation plate and the sacrificial anode on the drive in the picture... see how it looks identical to the SSM IV profile? The drive does appear to have a spacer installed... you can see the place where the rams were installed...
#9
Ginger or Mary Ann?
Charter Member
looks like there are 2 places for the ram locations
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
#10
Gold Member
Gold Member
Join Date: Feb 2003
Location: Carlsbad, CA
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
I was referring to the front mounting location where the ram attaches to the gimble. You are referring to the rear ram mounting location where it attaches to the lower unit (or in this case the 2 inch spacer).