Horsepower and Torque through Bravo 1
#11
Registered
Thread Starter
Join Date: Sep 2001
Location: Connecticut
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
![Post](/forums/images/icons/icon1.gif)
Puder, my spelling ACE....
Going to put about 530hp through the drive, around 650lbs of torque..
This is my project for the winter so hang on!
I think I should see around 70+
Time will tell.
Sheikman
Going to put about 530hp through the drive, around 650lbs of torque..
This is my project for the winter so hang on!
I think I should see around 70+
Time will tell.
Sheikman
#12
Guest
Posts: n/a
![Post](/forums/images/icons/icon1.gif)
Sheikman I put 547hp and 602# through 13 year old bravos and so far so good. Twins on a old Fountian my guess is 8000# for weight. They have held up and I pound em all the time. Thet are going in to be torn down and checked out this weekend. I'll let you know how they look.
#13
speel chekk this fokker!
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
![Post](/forums/images/icons/icon1.gif)
sheik you should be fine with that much power and a bravo. You prolly won't even have to baby it that much.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
#14
Guest
Posts: n/a
![Wink](/forums/images/icons/icon12.gif)
I have a 632 10.5 /1 Naturally aspirated pump gas motor putting 900 hp and 806 ft/# through my bravo. Had 1 floor seperate @4 hrs mainly due to factory set-up "loose". No problems since fix and corrected set-up. (drive does have hard shafts throughout) Here are the killers in my opinion, BIG TORQUE I.E. "Hot" blower motors and even more so...in and out of waves. I have a high "X" so the prop will "momentairly" come out when rough chop / small waves are encountered even when you don't feel anything from the hull. You have to pick and choose your water.
![EEK!](/forums/images/smilies/eek.gif)
![EEK!](/forums/images/smilies/eek.gif)
![EEK!](/forums/images/smilies/eek.gif)
#16
Registered
![Post](/forums/images/icons/icon1.gif)
Hey merlin, have you looked at the old short shaft drive jdnca dropped off last week? I think the cone clutch may be toast from dropping it in gear at too high of rpm. Damn those big roller cams! Have you got headers for your new Skater yet? I saw some new big tubes today 4,000/set.
later!
Whats up jdnca?
later!
Whats up jdnca?
Thread
Thread Starter
Forum
Replies
Last Post
phughes69
General Q & A
5
08-09-2007 06:03 PM