Big Block Chevy Intake decision
#61
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Is that a flat tappet speedracer? If so what is the part number and mfgr? I have been looking at a comp cam 11-240-4, 564/567 278/292 with a 112LS. Wouldn't mind checking yours out if you have the info handy.
BT
BT
#64
Charter Member #927
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
Originally Posted by blue thunder
My engines are 469cid (.070 over)
![Cool](/forums/images/smilies/cool.gif)
![Cool](/forums/images/smilies/cool.gif)
Great info on the intakes everyone!!
#65
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I believe mark IV 454s can go to .120 over, depending on how much hp you are pushing. The wall starts getting weaker and moves more the further you go. Problem with most marine engines (unless closed cooled), is corrosion is working on the other side of the cylinder wall to make it even thinner. There are things that can be done to counter the flexing wall issue, like putting cement in the water jackets to stiffen things up. I run closed cooling, so the .070 doesn't bother me a bit but without it I think I would start getting nervous over .060 over.
BT
BT
![Cool](/forums/images/smilies/cool.gif)
#67
Registered
Thread Starter
Join Date: Jan 2001
Location: rochester, ny
Posts: 978
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
bt,
I do not have those specs, sorry. I remember looking up the cam on Isky's site. I don't believe that they had it there either.
I do not have those specs, sorry. I remember looking up the cam on Isky's site. I don't believe that they had it there either.
Thread
Thread Starter
Forum
Replies
Last Post
Dennis Moore
General Q & A
32
02-12-2003 12:05 PM