Trs Drive Allignment?
#11
Registered
Doesn't the big donut seal #16 center the tailstock in the hole in the gimble assembly? Also keep in mind the hole in the gimble assembly in which the trans tailstock slides into is not aligned with the hole out side which the bellows is connected to. There is a step between these 2 holes which makes the tailstock appear lower when looking at it from the outside. You can see the step in the pic below the letter "A".
I do realize you also need the bolt stack correct.
I do realize you also need the bolt stack correct.
#12
Registered
I followed Brian's stack up but need to clairify if I have it right.
The way I assembled it was this from top down:
Bolt/ head of bolt
steel washer
trans rubber mount
fiber washer
Thackery spring inside of the large steel washer
fiber washer
transom mount
Nylock nut
The part I am confused about is if there should be 1 or 2 fiber washers between the trans mount and the tailstock?
I used this picture and Brians post as a reference.
The way I assembled it was this from top down:
Bolt/ head of bolt
steel washer
trans rubber mount
fiber washer
Thackery spring inside of the large steel washer
fiber washer
transom mount
Nylock nut
The part I am confused about is if there should be 1 or 2 fiber washers between the trans mount and the tailstock?
I used this picture and Brians post as a reference.
Last edited by picklenjim; 07-04-2012 at 11:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
thayes11
General Q & A
0
10-02-2005 12:36 PM
Cord
General Boating Discussion
5
03-28-2002 11:08 PM
panteraracin
General Q & A
3
02-07-2002 10:36 PM