Leak Down Test
#1
Registered
Thread Starter
Join Date: Jun 2002
Location: WEST MONROE,LA.
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Ok, Iam Looking At A Boat W/ 500efi With Only 14 Hours. I Had A Comp. Test Done 150-152 Across The Board. Good. The Leak Down Was 18%on The Low Side And 26% The Highest. The Boat Has Been Sitting-up Around 6 Months. What Do You Guys Think. Also The Motors Are 2002. Thanks In Advance.
#2
Registered
![Default](/forums/images/icons/icon1.gif)
18 TO 26 PERCENT IS NOT THE GREATEST CONDITION FOR A LEAK DOWN YOU MAY WANT TO RESEARCH THAT A BIT FURTHER TO SEE WERE THE LEAK IS GOING IF ITS PAST THE VALVES ITS NOT TO BAD A VALVE JOB WILL MOST LIKELY FIX IT BUT IT MAY BE FURTHER INVOLVED.HOPE THIS SHINES A LIGHT LAZ MESA WWW.MESABALANCING.COM
#3
Registered
Join Date: Sep 2001
Location: Houston, TX, USA
Posts: 2,287
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
That is bad leakdown for a motor only having 14 hrs on it. Last winter I did leak down on a motor that I run on the edge of detonation with 10+ lbs of boost & worse was 15% after 100 hrs.
#5
Registered
Thread Starter
Join Date: Jun 2002
Location: WEST MONROE,LA.
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I Think It Is Due To The Time The Boat Has Set-up. Could Rust Have Got On The Values And Caused The Values Not To Seal. And Would Running The Boat Blow The Rust Out And Fix The Seal Issue.
#6
speel chekk this fokker!
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
i was always told a cold leakdown test is a 1/2 step above useless. The engeinmust be at or close to operatign temperature so everything will seal right and not leak.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
#8
Registered
Join Date: Jan 2004
Location: San Diego, California
Posts: 2,777
Likes: 0
Received 6 Likes
on
6 Posts
![Default](/forums/images/icons/icon1.gif)
I agree, change the oil and filter first, put some time on the motors under load and then recheck the leakdowns on warm motors. If its just a little valve seat rust it will probably improve a lot. If it does not then squirt a little oil carefully in each cylinder and retest. If it then improves a moderate amount you've probably got ring issues and if it is still higher than 15%, you've got a major rebuild in order and the boat should price accordingly.
Raylar
Raylar
#10
Registered
Thread Starter
Join Date: Jun 2002
Location: WEST MONROE,LA.
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Originally Posted by Infomaniac
Leak down the engine while still warm.