2.5 HP per cubic inch, How hard is it?
02-11-2005, 06:20 PM
#11
Registered
Thread Starter
Re: 2.5 HP per cubic inch, How hard is it?
Just wanted to see what other options are out there. Always open to new ideas, I'm not running M2 heads.
Last edited by GPM; 02-11-2005 at 06:39 PM.
02-11-2005, 07:10 PM
#12
Registered
Re: 2.5 HP per cubic inch, How hard is it?
Sorry GPM, I thought you were running the M2's. So what heads are you running and do you have an estimate as to how much HP it takes to turn blower at 15 lbs of boost on a 598 at say a marine friendly 6500 RPM? I have heard it takes about 800 HP to turn the blowers on Top Fuel cars at WOT!!!! 
What about different blowers in this application? Which is the least parasitic? Turbos don't rob as much as blowers right? I would imagine at these power levels this becomes a factor!!
Craig
What about different blowers in this application? Which is the least parasitic? Turbos don't rob as much as blowers right? I would imagine at these power levels this becomes a factor!!Craig
02-11-2005, 07:34 PM
#13
Registered
Thread Starter
Re: 2.5 HP per cubic inch, How hard is it?
I did run the M2 BB2 xtra at one time, I switched to the Big Duke just to see if they lie about the extra power, they don't. I only have experience with the procharger, and I can only guesstimate from dyno hp and fuel consumption on the data logger. I calculated about 235 hp to run the blower. I'm sure the turbo would be more efficiant, I don't know how the water jacketed turbo would spool, and would it just rip the lower unit off the boat.
Last edited by GPM; 02-11-2005 at 10:25 PM.
02-11-2005, 07:54 PM
#14
Guest
Posts: n/a
Re: 2.5 HP per cubic inch, How hard is it?
Originally Posted by GPM
I did run the M2 BB2 xtra at one time, I switched to the Big Duke just to see if they lie about the extra power, they don't.
, gotta pay to play! 
02-12-2005, 12:39 AM
#17
Platinum Member
Platinum Member
Re: 2.5 HP per cubic inch, How hard is it?
A garden variety 600cc Jap sportbike fits the bill at 115hp and 36 cubes.
And easy? Walk in and sign your name. That's pretty easy.
And easy? Walk in and sign your name. That's pretty easy.
02-12-2005, 07:46 PM
#19
Registered
Thread Starter
Re: 2.5 HP per cubic inch, How hard is it?
Originally Posted by mcollinstn
A garden variety 600cc Jap sportbike fits the bill at 115hp and 36 cubes.
And easy? Walk in and sign your name. That's pretty easy.
And easy? Walk in and sign your name. That's pretty easy.
02-12-2005, 08:08 PM
#20
Registered
Thread Starter
Re: 2.5 HP per cubic inch, How hard is it?
Originally Posted by RichardCranium572
Eliminator's/Bob Leach's 572's were 1500hp @15 lbs boost. Quad Whipple EFI.
Any clue to the combo? sure would like to see those dyno sheets! what boat did Bob run them in?
Thread
Thread Starter
Forum
Replies
Last Post
ratman
General Boating Discussion
49
07-26-2006 08:43 PM
