Sheet Metal Intake!
02-23-2005, 04:58 PM
#41
Charter Member #601
Charter Member
Re: Sheet Metal Intake!
Hey CNC,
Was that the one sitting on the bench over by the dyno? I looked at it, but should have looked closer. Is Steve building them himself? Or does he have them done? And what kind of money does he want for them?
Thanks
Dick
PS.. I have some numbers for you. I just need to verify them. I have been swamped with tax time stuff..
Was that the one sitting on the bench over by the dyno? I looked at it, but should have looked closer. Is Steve building them himself? Or does he have them done? And what kind of money does he want for them?
Thanks
Dick
PS.. I have some numbers for you. I just need to verify them. I have been swamped with tax time stuff..
Thread
Thread Starter
Forum
Replies
Last Post
Rambunctious
General Q & A
5
12-13-2007 09:35 PM
Craig B
General Q & A
3
06-19-2006 06:05 PM
