water pressure
#1
Registered
Thread Starter
Join Date: Oct 2002
Location: brewerton n.y.
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
can anyone tell me if there is a better location to draw water pressure from rather than the bottom side ofthe block.and the best place to install a pop off valve.thanks.
#2
Registered
![Default](/forums/images/icons/icon1.gif)
My pressure is taken from the intake manifolds...the pop-off valves are installed just prior to entering the cross-overs and dump out the side of the boat. Pressure is around 28 psi @ full throttle which is the pressure valves by-pass. The lower block location tend to become clogged over time (fresh water cooled)
Bob
Bob
#4
Registered
![Default](/forums/images/icons/icon1.gif)
Originally Posted by Python82
What kind of pop off valves are most people using??? and do you install it before the water goes into the crossover???
Thanks
Thanks
installed before the crossover ... and after the oil cooler ...
Bob
#6
Registered
![Default](/forums/images/icons/icon1.gif)
#8
Registered
![Default](/forums/images/icons/icon1.gif)
Originally Posted by mv35
bob thanks for the info.where did you tap your water pressure line from the intakes.i have supercharged engines w\no thermostats.
Bob
Last edited by 737jetmech; 02-25-2005 at 08:50 PM. Reason: add picture
Thread
Thread Starter
Forum
Replies
Last Post
Zanie
General Q & A
5
03-10-2005 10:58 AM
28Eliminator
General Q & A
11
06-22-2004 10:43 PM