Mefi On the Water Tune wanted
#1
Registered
Thread Starter
Mefi On the Water Tune wanted
Can anyone recommend or know of anyone that does water tuning in SE Michigan. I did a mail order on my 502 build and don't feel it's up to the potential of the engine.
I could DIY if I had the software, and don't want to be bothered learning to tune marine stuff from scratch if the cal is locked out. The boat is my relief from my job in the auto industry.
Thanks.
I could DIY if I had the software, and don't want to be bothered learning to tune marine stuff from scratch if the cal is locked out. The boat is my relief from my job in the auto industry.
Thanks.
#2
Registered
Arcticfriends is in Frankenmuth. I’m sure slammed by he’s s terrific person
The following 2 users liked this post by SB:
articfriends (09-16-2022), Gimme Fuel (08-02-2021)
#3
Registered
Thread Starter
That's a hike for me from Wyandotte. But I'd pay mileage if he'd drive down this fall. This isn't something I need right now.
I built one of the best engine I've assembled in 36 years of building engines and hydroplane racing... and the boat is no faster than stock. Runs good, but doesn't add up. I'm just looking for 5 mph. From 55 to 60 in an Envision P'Zazz 2600. Almost identical to a Powerquest 260 Legend.
I built one of the best engine I've assembled in 36 years of building engines and hydroplane racing... and the boat is no faster than stock. Runs good, but doesn't add up. I'm just looking for 5 mph. From 55 to 60 in an Envision P'Zazz 2600. Almost identical to a Powerquest 260 Legend.
The following users liked this post:
articfriends (09-16-2022)
The following users liked this post:
jriggs (09-08-2021)