Keith Eickert Patented Easy Adjust 2-Piece Valve Cover System
#22
Registered
yes my rails are the problem i checked them with a set of calipers and the middle is about .080 spread apart from what the cover is so the o ring doesnt seal very good if at all
#23
doing this 50 years.all i can say is this should be your biggest problem. magnum mark.
#26
Registered
post # 162 .... It would not let me post em on this thread ....m
http://www.offshoreonly.com/forums/s...hlight=project
#27
Registered
post # 162 .... It would not let me post em on this thread ....m
http://www.offshoreonly.com/forums/s...hlight=project
http://www.offshoreonly.com/forums/s...hlight=project
#28
Only the Best Will Do!
Thread Starter
Join Date: Nov 2004
Location: Palm Coast, FL
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
Is this the remote mount you are looking for?
http://www.keitheickert.com/detail~ID~266.aspx
Or are you looking for the thermostatic remote mount?
http://www.keitheickert.com/detail~ID~264.aspx
I have both on hand and can ship today. You can e-mail me at [email protected] or call at (386) 446-0660.
http://www.keitheickert.com/detail~ID~266.aspx
Or are you looking for the thermostatic remote mount?
http://www.keitheickert.com/detail~ID~264.aspx
I have both on hand and can ship today. You can e-mail me at [email protected] or call at (386) 446-0660.
#30
Registered
I have stud girdles and they fit fine on the Scorpion's 540's. The ones on there were purchased in 2000, don't leak at all, and I purchased another pair to put on the Black Thunder when I work on those motors. The girdle number was PF 13602-1, whatever that means. If you want, I could call my engine builder to see what make that is.