625 Ilmor in a Heat
#1
Registered
Thread Starter
Join Date: Mar 2007
Location: Utah
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
625 Ilmor in a Heat
Toying with engine upgrades for an '06 Heat. Looking at several options, one being the 625 Ilmor. Spoke with a person at Nordic who said it should fit without modding the seat etc, but everything I have read indicates the Ilmor is about 4.5 inches longer than the 496 HO, which is nearly touching the back of the seat. Anyone have experience rigging one of these. Thanks
Last edited by chase8; 02-16-2011 at 04:12 PM.
#2
Registered
Toying with engine upgrades for an '06 Heat. Looking at several options, one being the 625 Ilmor. Spoke with a person at Nordic who said it should fit without modding the seat etc, but everything I have read indicates the Ilmor is about 4.5 inches longer than the 496 HO, which is nearly touching the back of the seat. Anyone have experience rigging one of these. Thanks
#3
Registered
Southocg has one.
After CB-BLR went through and methodically set it it up - it ran 90.
Uncle Dave
#4
Registered
Thread Starter
Join Date: Mar 2007
Location: Utah
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
Yes, I have found a few threads about the 710 in a heat. Nordic says they have set up a few heats with the Ilmors. He was not sure what year the boats were, but it is notable because in '08 Nordic moved the rear seat forward 2". He said this was not done to make more room under the hatch, but as part of a new (no wood) lay up process. Ultimately I guess it would not be that difficult to move the seat forward an inch or two if needed. Thanks for the input.