combat zone 24 restoration
#1
Registered
Thread Starter
Join Date: Aug 2010
Location: MA
Posts: 2,535
Likes: 0
Received 0 Likes
on
0 Posts
combat zone 24 restoration
Heres some pics, the transom got filled to ditch the trs in favor of an xr. Filled some holes on the dash for a new layout. More pics with fresh paint next week.
#5
Registered
Who did the pic? I need to do that for some ideas I have for my boat
#6
Registered
I like the green rub rail a lot, but I suspect it will really show the wear after it's taken a little abuse. Personally I'd go with black so it hides the wear better.
Looking good Mike!!!
Looking good Mike!!!
#7
Registered
Platinum Member
Its Photo Shop CS5 Commercial that runs the wrap and sign shop $1700. That was five minutes but if I sit down and take my time I can make it look like a real photo . You can do the same thin with any photoshop once you figure it out .
Last edited by OCCJoe; 02-04-2012 at 08:43 PM.
#8
Registered
Guess its time to get photoshop loaded in my laptop
#9
Charter Member
Charter Member
I would do a std rubrail, alum or black and tape or paint green the uderside of the overhang and a 1.5" stripe on the hullside below that so it looks similar to the photo but it gives a little 3D effect to the green over the black.
Last edited by IRONMAN; 02-04-2012 at 09:43 PM. Reason: add
#10
Gold Member
Gold Member
Join Date: Jul 2004
Location: Croton, MI
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
I think Ironman has the ticket! Nice looking rendition. Did you buy that boat out of Montague, MI.? I saw it there a few years back.