The "New Powerplay"
#64
Registered
Thread Starter
Join Date: Feb 2012
Location: South Florida
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
J, *135 inches from inside the transom to the dash board bulkhead. To do staggered motors we need approx 80 " of motor box. Each bolster needs at least *24 inches front to back plus room to get in and out . It can be done but you would have to give up some cabin space which we could do with a temporary insert in the mold. Also, there would be lots of custom work on the *cabin door, floor, etc. a new motor box mold and you might have to give up some fuel . Also I'm not trying to make any money here but it will cost an additional $30,000 to $35,000 *for the custom glass work and *take about 6 to 9 months
#65
Registered
Tom, if and only if I was to do anything I would want a 6pk with the front bolsters and 3 holes in the back plus a cabin. And I would do my own power. I work with another builder and am very aware of the cost to do a boat similiar to what I want. I can rig it and do anything myself. The comment I made about a 700sci stagger was if I won the powerball. That said I really hope you guys can sell some boats and pull it off. I really would like to see one before I would do anything. But now that someone has the molds and are willing to do boats I am not opposed to seeing what you produce and might be willing to do a blank hull for the right $$$.
#68
Registered