PQ General Discussion
#3741
Registered
#3743
Registered
Gold Member
Couldn't let this gem get too many pages back...
So I pulled the drives on the 300 to check the u-joints and gimbles. Everything's perfect, but putting new bearings in anyway. I'm also, going to buy the stainless sea pumps, add another sub, and probably underwater led's, and some more cockpit led's. All this and I might list it in the spring, who knows. Thinking bigger.
Anyone else doing anything interesting?
So I pulled the drives on the 300 to check the u-joints and gimbles. Everything's perfect, but putting new bearings in anyway. I'm also, going to buy the stainless sea pumps, add another sub, and probably underwater led's, and some more cockpit led's. All this and I might list it in the spring, who knows. Thinking bigger.
Anyone else doing anything interesting?
#3745
Registered
#3746
Registered
Join Date: Aug 2010
Location: WI
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
#3747
Registered
#3748
Registered
Join Date: Aug 2010
Location: WI
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
Same motor but port side was the hardest for me, not sure if all revenages have them or not but in front of the port motor I have a pretty deep box that stores the anchor and some fenders, it is almost the width of the platform and I am not small enough to fix between it and the port side of the boat. It makes working on anything on the port motor, port side interesting. I for the life of me can't find the screws that hold it place. I swear they carpeted the thing after they put it in.
#3749
Registered
Here are my updates:
- fix my toilet
- new GPS speedo
- drives looked at
- repair latch on fridge
- all new stereo - already ordered it all
- get a few paint spots fixed
- new props
- change halogen cabin lights to LED - too hot for my daughter
- repair zipper on gunwhale
That's it, then ready for Florida in February.
- fix my toilet
- new GPS speedo
- drives looked at
- repair latch on fridge
- all new stereo - already ordered it all
- get a few paint spots fixed
- new props
- change halogen cabin lights to LED - too hot for my daughter
- repair zipper on gunwhale
That's it, then ready for Florida in February.
#3750
Registered
Gold Member
Same motor but port side was the hardest for me, not sure if all revenages have them or not but in front of the port motor I have a pretty deep box that stores the anchor and some fenders, it is almost the width of the platform and I am not small enough to fix between it and the port side of the boat. It makes working on anything on the port motor, port side interesting. I for the life of me can't find the screws that hold it place. I swear they carpeted the thing after they put it in.