29 six blade herrings
#1
Registered
Thread Starter
Join Date: Jan 2003
Location: Pgh. Pa.
Posts: 853
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
any one looking for a set ,xr shaft 15 1/8 diameter very nice compatible to 32-33 labbed bravo 30 p5x ,4mph to 5mph faster my slip went from12% to 7% mid range is 11 mph faster call Bob 4127810881 first 2800.00 goes,faster
Last edited by crayolacrazy; 05-21-2008 at 07:21 PM.
#3
Registered
Thread Starter
Join Date: Jan 2003
Location: Pgh. Pa.
Posts: 853
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
4000.00 try to get aset at least 2 month they wont work on small shaft they are solid hubs, who labbed your p5x,s and what was the gain
Last edited by crayolacrazy; 05-21-2008 at 07:09 PM.
#4
![Default](/forums/images/icons/icon1.gif)
Bblades labbed them. I had them labbed the first time last year. After labbing, they ran the same rpms, and accelerated better. I only picked up about 1 mph, but to Brett's defense this test came in the heat of summer. I had him lab them again to try to pick up a few more rpms, haven't been able to test them as of yet. Took the difuser ring off, big mistake, Brett is in the process of re-installing them.
#5
Registered
![Default](/forums/images/icons/icon1.gif)
What hull were these done for/run on? And why are you selling them?
#6
Registered
Thread Starter
Join Date: Jan 2003
Location: Pgh. Pa.
Posts: 853
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
they came off of a 42 fountain I ran them as my rough water props on a 33outlaw with twin 800whipple motors I have 6 different sets of props that all work on my boat,how many do I need? My motors make over 800lbs of toque at 3500 rpms and with those 29s my slip went from 12% to 7% thats to hard on my drives 5blades are more fogiveing
Thread
Thread Starter
Forum
Replies
Last Post
SummerObsession
General Racing Discussion
7
06-17-2004 03:59 PM