HART THROB resto / upgrade
#11
Registered
Thread Starter
all of the thru holes got doweled 1/2 inch short so there was a quarter on each side to seal it off and glass it
Last edited by outonsafari; 11-13-2017 at 07:25 PM.
#12
Registered
Thread Starter
drilled out new drain holes, plugged old, broke a hole saw doing it but stringers are dry and new holes are wrapped in 1708
Last edited by outonsafari; 11-13-2017 at 07:07 PM.
#13
Registered
Thread Starter
more of the drains
#14
Registered
Thread Starter
last of the holes
#16
Registered
Thread Starter
how long, 16 months, and thinking that thru i shoulda been done 10 months ago, and probably would've been if it was inside.
#18
Gold Member
Gold Member
Looking good man!
keep chugging! Those pics bring back a lot of memories from when I was where you're at now.
what brand of boat is it? Maybe I missed that part
keep chugging! Those pics bring back a lot of memories from when I was where you're at now.
what brand of boat is it? Maybe I missed that part
#19
Gold Member
Gold Member
#20
Registered
Thread Starter
26' modern marine 1995.
story goes some guys got use of "the old monza molds"
i don't know how many built, a few maybe and 1 race boat.
the race boat ran the 96 season, then for whatever reason it was derigged , mothballed etc.
the original owner / builder kept it until i got it.
2more pics as i got it
story goes some guys got use of "the old monza molds"
i don't know how many built, a few maybe and 1 race boat.
the race boat ran the 96 season, then for whatever reason it was derigged , mothballed etc.
the original owner / builder kept it until i got it.
2more pics as i got it
Last edited by outonsafari; 11-14-2017 at 07:21 PM. Reason: pics