81 Scarab project from hell
#281
![Default](/forums/images/icons/icon1.gif)
I know what I would do if this was going into my corvette, but I am new to the boat thing, so I am unsure. I think the same principles apply in that you want good oil control and you want that oil to be at the pick-up no matter what. My small blocks have pans on them that have an extra long sump and the sump is a little deeper that the stock chevy. Can you run a stock pan with an oil accumulator? Poor mans dry sump....
#282
Registered
![Default](/forums/images/icons/icon1.gif)
There should be a port on your raw water pump for the tranny cooler. (a 1/4" plug that you can put a nipple in.)
My pans are the stock 6qt truck pans that came on the motors from merc....In fact I think one of them has a trap door and the other doesen't. If I had it to do over again I would look into a bigger pan....I don't have any comments on your mallary stuff. I am running GM HEI's just like the merc 500EFI's run
My pans are the stock 6qt truck pans that came on the motors from merc....In fact I think one of them has a trap door and the other doesen't. If I had it to do over again I would look into a bigger pan....I don't have any comments on your mallary stuff. I am running GM HEI's just like the merc 500EFI's run
![Smilie](/forums/images/smilies/smile.gif)
#285
Registered
Thread Starter
Join Date: Jul 2005
Location: Spokane, Washington
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
#286
Registered
Thread Starter
Join Date: Jul 2005
Location: Spokane, Washington
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
#287
#288
Registered
![Default](/forums/images/icons/icon1.gif)
Mine goes from the raw water pump straight to the tranny and out the side of the boat....why would you want it to go to your thermostat housing?
#289
Registered
![Default](/forums/images/icons/icon1.gif)
![Cool](/forums/images/smilies/cool.gif)
![Cool](/forums/images/smilies/cool.gif)
![Cool](/forums/images/smilies/cool.gif)
#290
Registered
Thread Starter
Join Date: Jul 2005
Location: Spokane, Washington
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Bit the bullet and ordered Miloden 7 quart pans- got the dash out for graphics, ordered all the wiring to redo the trim pumps and bilge pumps, and basically accomplished nothing this weekend except mow the lawn. Put some time on the Waverunner- need to grab my GPS- speedo showed 79!!
![Drink](/forums/images/smilies/drink.gif)